Yard Force SC600ECO Originalanleitung Seite 17

INSTALLATION GUIDE
charging station, see below and if all is ok, it should light up with constant blue. If no LED
is lit, check the power connections firstly, if LED is on but not constant blue refer to the
trouble shooting guide below.
LED
1 Blue light on Normal
2 Blue flash, Red off Charging station internal wire break, main Boundary is OK
Boundary cut off or poor connect, charging station internal wire
3 Red flash, Blue off
is OK or the mower is charging, it's ok.
Boundary and charging station internal wire both short circuit or
4 Red and Blue flash
cut off
4.7. Turn On and Test the Installation
LED
Once the LED light is constant blue, this means all is ok so now the Boundary wire pegs
can be knocked fully with hammer. Once this is done, double check the light is still blue
if yes then the boundary and charging station are all working as normal. Then place the
YARD FORCE Robotic Lawnmower in the working area, a few meters beside the charging
station.
Press the Mower Power isolated switch to "ON". (Press again for OFF)
Description
30
INSTALLATION GUIDE
See later for further explanation.
Now press the large STOP button on top of Mower then the keypad top cover will open.
Power Isolation
switch status:
OFF (Released)
Press the key Marked HOME (situated to left of display) and then manually press the top
cover to closed position. Once closed the Mower should start and will automatically return
to the Charging station by locating a Boundary wire and following it. The mower should
follow the wire in an anti-clockwise direction and when gets close to the Charging station
and dock into charging position. The mower will start to fully charge. If robot misses to
dock, you might have to adjust the charging station sideways until robot docks without any
problem.
Set
The LED above the symbol will light, which means that the robot mower is charging
now.
Power Isolation
switch status:
ON (Pressed)
Home
Start
31