Status Indicator; Programming - Yard Force SC600ECO Originalanleitung

PROGRAMMING

5.3. Status indicator

5.3.1 Lift signal
Red LED above this symbol shining! When the robot mower is lifted.
Note! Lift signal could also be generated by a vibration on the robot.
After short time (< 1 second) be lifed, the robot mower will return to work normal. In case
the lift signal last more than 1 sencond and less than 8 seconds, robot will stop and later
restart automatically. In case the lift signal last more than 8 seconds, robot mower will
lock itself automatically for anti-theft and alarms.
5.3.2 Boundary wire signal
The boundary wire is generating a boundary signal, therefore the closer to the boundary
wire the stronger the robot mower will receive.
Red LED above this symbol shining! Means no signal. In this case robot mower stops
cutting.
5.3.3 Low Battery remain symbol.
Red LED above this symbol shining! Means battery remain capacity is very low.
5.3.4 Charging
LED above this symbol flashing! Means mover is charging on charging station. When
battery full charged, the LED will turn to solid
5.4 Setting
5.4.1 set working time
You can according to the "Zone 2" of picture oval within the four buttons to set your
working time. If you want to change the time setting, you can reset your working time by
pressing different buttons what you need (only one button will be bright). Please note that
working time will be implemented immediately after you set up. If you set your machine
at 10 a.m., it also means that your machine will start work from 10 o'clock in the morning
every day.
Recommended time per day(hour)
300m 2
2
600m
After the working time is selected, the corresponding LED will be lit up
LED flash means out of working time
4hours
6hours
34
PROGRAMMING
5.4.2 set the Mode
You can select working mode S1 or S2 to your machine, if there's another machine near
your working area, with the mode of S1, then you can select S2 to your machine to avoid
any signal interference.
After the working mode is selected, the corresponding LED will be lit up.
5.4.3 set signal of boundary
This Robot has two boundary wire signals, Signal 1(S1) and Signal 2(S2). When your
neighbor purchase the same robot, it is highly recommended that you set them on different
signals to prevent disturb to each other.
Firstly when you connect the boundary wire to the charging station, make sure you are
aware of which signal (S1 or S2) is generated from the charging station.
Press S1 or S2 on the control panel, make sure it same with charging stating wire
connection.
Anschluss F
Anschluss B
35