Yard Force SC600ECO Originalanleitung Seite 10

UNDERSTANDING THE ROBOTIC MOWER
3.2.4. YARD FORCE Robotic Mower Mowing Limitations
The YARD FORCE robotic lawnmower is programmed by manufacturer to cut 4 hours.
from current time every day but as every garden will be different and if you want to change
these settings, it is easy to program this by yourself see instructions which listed at follow
chapter.
If your neighbor is using a YARD FORCE Robotic Lawnmower also, you need keep a 0.5 m
distance between your and neighbor's boundary wires to eliminate interference. And you
need keep your charging station more than 10 m from your neighbor's boundary wires, and
you have to set a different boundary signal from neighbor's as signal S1 or S2. Ref. 5.4.3
"Signal setting".
Own land
S1
Below is a table showing the signal distances for each of the Robot Mowers, please note
your model and use this information as your guide when designing the boundary layout.
Model Max field
SC600ECO 600 m
NOTE ! When the working area is less than 100 m
40 m, please connect a 10 Ω / 20 W cement resistance to the boundary wire, or contact
the service.
When the working area is less
than 100 m
wire less than 40m, please
connect a 10 Ω / 20 W cement
resistance to the boundary wire
> 10 m
Neighbour
S2
> 0,5 m
> 10 m
Distance of receive the signal
L
2
12.5 m
2 or total boundary wire less than
2
or total boundary
＜100 m
2
16
UNDERSTANDING THE ROBOTIC MOWER
3.2.5. YARD FORCE Robotic Mower Cutting Information
The YARD FORCE Robotic Lawnmower has 5 cut height settings between 20mm to 60mm.
If the grass height is higher than 60 cm, you need cut this grass down to at least 60mm,
otherwise the load on the unit will be too large and the cutting efficiency will suffer. Use
a normal lawn mower or a grass trimmer. Once the installation is completed, the cut can
be adjusted to one of the 5 settings of your choice. Always start in a high cutting position
and work yourself down to the cutting height you want. This is carried out by lifting the lid
shown and adjusting the large rotating dial here. Note do not attempt to raise or lower the
cut height during cutting and always.
The YARD FORCE Robotic Lawnmower can cut wet grass but wet grass will accumulate
on the blade disc and wheels which means more frequent cleaning of unit.
Do not use the YARD FORCE Robotic Lawnmower during lightning or thunder storms
in case of damage to the electronic circuitry, it is recommended to unplug the charging
station, and disconnect the boundary wire also if possible.
The YARD FORCE Robotic Lawnmower cutting efficiency relies on sharp blades, so please
keep them in good condition.
17