Maintenance And Service - BTI PROFI Line -BH 36 VLI Bedienungsanleitung

Screw Driving (see Fig.
Place the machine on the nut/screw only when it
is switched off.
To use screwdriver bits, a universal holder with SDS-
plus shaft 26 (accessory) is required.
Clean the adapter shaft and lightly grease the insertion
end before inserting.
Maintenance
For all work on the machine itself, remove the battery.
Always keep the machine and the ventilation slots
clean for proper and safe working.
Clean the tool holder after each use.
Replacing the Dust Protection Cap
Replace the dust protection cap 2 without delay if it is
damaged. A damaged dust protection cap can allow
dust to penetrate into the tool holder and lead to mal-
functions.
Have the replacement of the dust protection cap
performed by a customer service agent.
If the machine should fail despite the care taken in the
manufacture and testing, have the repair performed
exclusively by the BTI customer service.
For all inquires and replacement parts orders, please
include the article number on the nameplate of the ma-
chine in all cases.
Transport
The battery is tested according to UN Handbook
ST/SG/AC.10/11/Rev.3, Part III, Subsection 38.3. It
has effective protection against internal overpressure
and short circuiting as well as devices for the prevention
of forceful breaking and dangerous reverse current.
The quantity of lithium equivalent contained in the bat-
tery is below the relevant limiting values. Therefore,
the battery is not subject to the national and interna-
tional hazardous material regulations neither as an in-
dividual part nor when inserted in a machine. Howev-
er, the hazardous material regulations could become
relevant for the transporting of several batteries. In this
case, it could become necessary to observe special
requirements (e.g., for the packaging).
2 609 932 725 • (06.08) T
)
I

5 MAINTENANCE AND SERVICE

Insert the universal holder 26 with a twisting motion
into the tool holder 1 until it locks.
The universal holder locks itself. Check the locking by
pulling on the universal holder.
Insert a screwdriver bit into the universal holder.
To remove the universal holder 26, pull the locking
sleeve 3 to the rear, hold it in this position and remove
the universal holder from the tool holder.
Disposal
Power tools, accessories, and packaging should be
disposed of for recycling in an environmentally friendly
manner.
Only for EU countries
tools that are no longer usable must be collected sep-
arately and recycled in an environmentally friendly
manner.
Batteries
Do not throw batteries into the household waste, fire
or water. Batteries should be collected, recycled or
disposed of in an environmentally friendly manner.
Only for EU countries
According to the Guidelines 91/157/EEC, defective or
used batteries must be recycled.
Specifications subject to change without notice
English–8
Do not dispose of power tools in
household waste!
According to the European Guide Lines
2002/96/EC for waste electric and
electronic equipment and its imple-
mentation into national law, power
Li-Ion: Lithium-Ion
Please refer to the information in
the Transport Section.