Functional Description; Intended Use - Bosch 0 602 304 40. Betriebsanleitung

OBJ_BUCH-698-001.book Page 37 Thursday, September 3, 2009 12:19 PM
Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Connect the machine to a mains supply with
proper earthing connection. Socket outlet
and extension cable must be equipped with
an operative protective conductor.
Safety Warnings for the Power Supply
of High-frequency Tools
The safety warnings and working instruc-
tions of the frequency converter are to be
strictly observed! For detailed information,
contact the manufacturer of the frequency
converter.
The frequency converter must be secured
with a residual current protection device
when working in an environment where
special protection for persons is necessary.
The special protection of persons is re-
quired, for example, when working in damp
rooms or with materials that can produce
current-conducting dust. Not using a residual
current protection device can lead to electri-
cal shock, risk of fire, or serious injuries.
The residual current protection device
should be installed in the power supply net-
work only by a qualified electrician. Only in
this manner can proper functioning be en-
sured.
The output voltage and frequency of the fre-
quency converter must correspond with the
data on the type plate of the high-frequency
tool.
Operate the power tool exclusively with a
fitting plug. The CEE plug must be dimen-
sioned for the nominal current that the pow-
er tool requires (see "Technical Data").
Plug mounting and connection to the power
supply is to be carried out by a qualified
electrician trained in handling high-frequen-
cy tool systems.
Bosch Power Tools
Use only original cables! Before each use,
check the power tool, cable and plug for
possible damage. Cables and plugs may not
be repaired, but must be exchanged in order
to avoid danger.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

Applies for the following types:
– 0 602 301 4..
– 0 602 305 40.
– 0 602 306 434
– 0 602 324 40.
– 0 602 327 401
The machine is intended for sanding and polish-
ing metal and coated surfaces without the use
of water.
Applies for the following types:
– 0 602 304 40.
– 0 602 324 44., ... 464, ... 474, ... 434
– 0 602 329 4..
– 0 602 331 4..
– 0 602 332 4..
– 0 602 334 4..
– 0 602 335 0..
The machine is intended for cutting, roughing
and brushing of metal and stone materials with-
out the use of water.
For cutting metal, a special cutting guide (acces-
sory) must be used.
For cutting stone, a special cutting guide with
dust extraction protection guard (accessory)
must be used.
Applies for all types
Use only the blade guards and clamping nuts
provided or specifically released for this power
tool.
English | 37
3 609 929 B88 | (9/3/09)