Bosch 0 602 304 40. Betriebsanleitung Seite 47

OBJ_BUCH-698-001.book Page 47 Thursday, September 3, 2009 12:19 PM
Vibration-dampen-
ing Auxiliary Handle
(see figure C)
The vibration-dampening auxiliary handle reduc-
es the vibrations, making operation more com-
fortable and secure.
Operate your machine only with the auxilia-
ry handle 2.
– Screw the auxiliary handle 2 on the right or
left of the machine head depending on the
working method.
Do not make any alterations to the auxiliary
handle.
Do not continue to use an auxiliary handle if
it is damaged.
Hand Guard (see figure D)
Applies for the following types:
– 0 602 301 4.. – 0 602 324 40.
– 0 602 305 40. – 0 602 327 401
– 0 602 306 434
For operations with the rubber sanding
plate 20 or with the cup brush/wheel
brush/flap disc, always mount the hand
guard 12.
– The hand guard 12 is fastened with the auxil-
iary handle 2.
Mounting the Grinding Tools
General Information
Disconnect the power supply before mak-
ing any adjustments, changing accessories,
or placing the machine aside. This safety
measure prevents accidental starting of the
power tool.
Grinding and cutting discs become very hot
while working; do not touch until they have
cooled.
Pay attention to the dimensions of the grinding
tools. The mounting hole diameter must fit the
mounting flange without play. Do not use reduc-
ers or adapters.
– Clean the grinder spindle 3 and all parts to
be mounted.
Bosch Power Tools
After mounting the grinding tool and before
switching on, check that the grinding tool is
correctly mounted and that it can turn free-
ly. Make sure that the grinding tool does
not graze against the protection guard or
other parts.
Mounting Grinding or Cutting Discs
(see figures E1 E2)
–
Applies for the following types:
– 0 602 304 40.
– 0 602 324 44., ... 464,
... 474, ... 434
– 0 602 327 401
Installation
– Make sure that the fitting protection guard is
mounted (see "Mounting the Protective De-
vices", page 46).
– Place the clamping flange 13 on the grinder
spindle 3.
A plastic part (O-ring) is fitted around the cen-
tring collar of mounting flange 13. If the O-ring
is missing or damaged, it must immediately be
replaced before mounting flange 13 is mounted.
– Mount the desired grinding/cutting disc 14 in
the correct rotation direction onto the grind-
er spindle 3.
– Place the clamping nut 15 onto the spindle
thread so that the central recess of the
clamping nut faces upward.
– Tighten the clamping nut with two-pin span-
ner 16, while counter-holding the spanner
surfaces of the grinder spindle 3 with open-
end spanner 17.
Removal
– Hold the grinder spindle 3 on the spanner
surfaces with open-end spanner 17.
– Unscrew the clamping nut 15 from the grind-
er spindle with two-pin spanner 16, while
counter-holding the spanner surfaces with
open-end spanner 17.
– Afterwards, pull the grinding tool and the
mounting flange from the grinder spindle.
English | 47
– 0 602 329 4..
– 0 602 331 4..
– 0 602 332 4..
– 0 602 334 4..
3 609 929 B88 | (9/3/09)