PERFECTPRO UBOX-500R Bedienungsanleitung Seite 34

Clock time setting
Automatically updating the clock
Your radio will normally update the clock automatically using the DAB or FM signal. If no signal is
available, then you need to set the time manually. After a power failure the radio will then set its clock
the next time that you turn on the radio in DAB or FM mode. Alternatively you may specify that the
time is not automatically updated. In this case the clock must always be set manually after a power
interruption.
1
With your radio switched on, press the Menu button to access the menu for the current
mode.
2
Rotate the Tuning control knob to select "System" and
press the Tuning control knob to enter the system settings
menu.
3
Rotate the Tuning control knob to select "Time". Press the
Tuning control knob to enter the time setting menu.
Rotate the Tuning control knob to select "Time auto
4
update" and press the Tuning control knob to enter the
setting.
5
Rotate the Tuning control knob to choose an update
option from "Update from all" "Update from DAB" "Update
from FM" or "No update" as required. Press the Tuning
control knob to confirm your choice.
NOTE
If you select "Update from all", "Update from DAB", "Update from FM" the current time
received will be displayed. If no signal is found you should either position the radio or its
aerial so that a signal can be received, or revert to manual clock mode.
FM
<System
System
<Time
Time
<Time auto update >
Time auto update
<Update from all >
Time auto update
<Update from DAB >
Time auto update
<Update from FM
Time auto update
<No update
>
>
*
>
>
33