Cleaning - Zummo Z14 nature Bedienungsanleitung

6.9. CLEANING

The machine squeezing area and parts must be cleaned daily.

If the machine is in operation, stop it always using the Programmer button Stop. Never attempt to
stop the machine using the main switch. Failure to follow this recommendation will cause the
machine to stop in a position that impedes cleaning; possibly leading to breakage of parts due to
poor handling.

Disconnect the machine turning the power switch off (fig. 5). Then the digital display will turn off.
(Fig. 6).

Remove the Front Cover and wash it using a damp cloth. (ATTENTION! NEVER use products that
may scratch it).

Wash the containers.
Z14 Manual Mode:
- Remove the Filter tray to get access to the Juice tray fastening nuts (fig. 7).
- To remove the cups (fig. 8), we recommend that you loosen the fastening screws a little and
pull outwards; they will be released and can then be easily removed.
- Juice tray and Blade are removed by unscrewing the fastening nuts and pulling outwards
horizontally (fig. 9).
- Unscrew the Balls inside the Juice tray. Under each ball find a washer (fig.10). You may use a
dishwasher to wash Juice tray, Filter, Filter Tray and Blade. TAKE EXTRA CARE WITH THE
BLADE (fig. 2) since it is very sharp and may cause injuries.
Z14 Self-service Mode:
- Faucet tray, Juice tray and Blade are removed by unscrewing the fastening nuts and pulling
outwards horizontally. Unscrew the Balls inside the Juice tray (Fig. 10). There is one washer
underneath each Ball. Be careful not to lose them! You may use a dishwasher to wash Juice
tray, Filter and Blade (except the faucet tray). TAKE EXTRA CARE WITH THE BLADE (Fig.
3) since it is very sharp and may cause injuries.
- Wash the faucet tray using a damp cloth. (¡ATTENTION! NEVER use products that may scratch
it).

Once all plastic parts have been removed, clean the machine stainless steel front.
Assembly
After cleaning the whole unit, it is re-assembled as follows:
1 Fit the Cups on the machine front shafts and tighten the Fastening Nuts (fig. 8).
2 Fit the washers on the Juice tray and screw the Balls, making sure they are properly tightened
(fig.10).
3 Insert the blade in the squeezer tray and slot the ribs into the grooves of the balls. Check that
the blade slides easily.
4 Assemble both Juice tray and Blade in the machine's three shafts simultaneously. Never fit the
Blade on the Juice tray afterwards!! To introduce the Blade into the Blade shaft, slightly
press down the Blade push it into the shaft. ATTENTION!!! Never press down the metal
part of the Blade.
5 Fit the shafts and the pulp scraper filter in the filter, fit the filter correctly in its position in the filter
tray, self-service tray (THE DRIVE SHAFT SHOULD OVERHANG THE TRAY) (fig. 11-12) and
fit the set into the machine. Check that the tray or tank is fitted properly which will also indicate
that the filter is in the right position (THE DRIVE SHAFT SHOULD DOVETAIL WITH THE
HEXAGONAL FILTER ACTUATOR).
6 Fit the Front Cover in place by fitting its clasps into the slots. Make sure that the clasps fit
correctly into the slots. You will hear a small click (fig. 13).
7 Put the plastic containers base and the plastic containers in place.
32