Safety Warnings; General Power Tool Safety Warnings - Parkside PTS 500 C3 Bedienungs- Und Sicherheitshinweise

Suitable for:
Noise emission value:
Noise measurement value determined in accordance
with EN 60745. The A-weighted noise level of the
power tool is typically as follows:
Sound pressure
level L :
pA
Uncertainty K :
pA
Sound power
level L :
WA
Uncertainty K :
WA
Vibration emission value:
Cutting wood
Hand/arm
vibration a :
h,W
Uncertainty K:
Cutting metal
Hand/arm
vibration a :
h,M
Uncertainty K:
Cutting ceramic
Hand/arm
vibration a :
h
Uncertainty K:
WARNING!
Wear ear protection!
WARNING!
The vibration level varies in accordance
u
with the use of the power tool and may
be higher than the value specified in these
instructions in some cases. There is a risk of
underestimation of the vibration load if the
power tool is used regularly in this manner.
Try to keep the vibration loads as low as
possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the
working time. Wherein all states of operation
must be included (e.g. times when the power
tool is switched off and times where the
power tool is switched on but running without
load).
8 GB
bricks, concrete, stone and
similar abrasive type of
light weight construction
materials like hollow brick
and aerated concrete
97.2 dB(A)
3 dB(A)
108.2 dB(A)
3 dB(A)
3.809 m/s
2
1.5 m/s
2
6.188 m/s
2
1.5 m/s
2
4.272 m/s
2
1.5 m/s
2
NOTE
The vibration level specified in these
u
instructions has been measured in
accordance with a standardised measuring
procedure specified in EN 60745 and can
be used to make equipment comparisons.
The specified vibration emission value can
also be used to make an initial exposure
estimate.

Safety warnings

General power tool safety
Q
warnings
WARNING!
Read all safety warnings and all
u
instructions. Failure to follow the warnings
and instructions may result in electric shock,
fire and / or serious injury.
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
Work area safety
Keep work area clean and well lit.
1.
Cluttered or dark areas invite accidents.
Do not operate power tools in
2.
explosive atmospheres, such as in
the presence of flammable liquids,
gases or dust. Power tools create sparks
which may ignite the dust or fumes.
Keep children and bystanders away
3.
while operating a power tool.
Distractions can cause you to lose control.
Electrical safety
Power tool plugs must match the
1.
outlet. Never modify the plug in any
way. Do not use any adapter plugs
with earthed (grounded) power
tools. Unmodified plugs and matching
outlets will reduce risk of electric shock.
Avoid body contact with earthed or
2.
grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock if
your body is earthed or grounded.
Do not expose power tools to rain or
3.
wet conditions. Water entering a power
tool will increase the risk of electric shock.