Maintenance And Cleaning - Master R04 Bedienungsanleitung

Maintenance and Treatment

MAINTENANCE AND CLEANING

(1) Be sure to check all parts like all nuts, bolts, screws and frame in order to be sure that they
are tight and secure especially after you start to do the exercise . This is to assure that all
the parts are in good condition and not suffered any long-term wear that may cause the
machine break down..
(2) Periodically spray the plastic surface with cleaner to keep the dust, sweat and marks off your
unit.
(3) Periodically check the wheels under the knee bowls to ensure that they are tight and secure
and have not suffered any long term wear and tear.
Malfunctions and treatment
Malfunction
Base is unstable.
Handlebar or seat
cushion is shaking.
Loud noise from
the moving parts.
No resistance
when riding the
upright bike.
Advice to replace defective components immediately and/or keep the equipment out of use
until repair;
Pressing the button over 3 seconds will reset all
functional values to zero except ODO value
Reason
Floor is not flat or there is
1.
small object under the front or
rear stabilizer.
The rear stabilizer end caps
2.
have not been leveled when
assembling.
The bolts and saddle post knob
are loose.
The interval of the
improper tighten.
The interval of the magnetic
1.
resistance increases.
2. Tension control is damaged.
3. Running belt slips.
The bearing set is damaged.
4.
Remove the object.
1.
Adjust the rear stabilizer end
2.
caps.
Tighten the Bolts and saddle post
knob.
parts is Open the covers to adjust.
Open the covers to adjust.
1.
2. Change the tension control.
3. Open the covers to adjust.
Change the bearing set.
4.
60
Treatment
EN