Residual Heat Indication; Power And Super Power Function; Timer - Novy 1811 Bedienungsanleitung

After use, switch the heat element off: don't let the pan
detection [ U ] active.

4.2.3 Residual heat indication

After the switch off of a heating zone or the complete
stop of the hob, the heating zones are still hot and indi-
cates [ H ] on the display.
The symbol [ H ] disappears when the heating zones
may be touched without danger.
As far as the residual heat indicators are on light, don't
touch the heating zones and don't put any heat sensi-
tive object on them. There are risks of burn and fire.

4.2.4 Power and Super Power function

Power [ P ] and Super Power [
Power to the selected heating zone.
If this function is activated the heating zones work dur-
ing 10 minutes with an ultra high Power.
This is foreseen for example to heat up rapidly big
quantities of water, like nuddles
Start up / Stop the Power:
Action Control panel
Start up the Slide to the end of the
Power "SLIDER" or press
directly on the end of the
"SLIDER"
Stop the Slide on the "SLID-
Power ER"
Start up / Stop Super Power:
Action Control panel
Start up the Slide to the end of the
Power "SLIDER" or press di-
rectly on the end of
the "SLIDER"
Start up Su- Re-press key [ P ]
per Power
Stop the Slide on the "SLIDER"
Super
Power
Stop Power Slide on the "SLIDER"
Power management:
The table is divided in 2 separate sets of heating zones,
each set having a maximum power.
If the selected heating levels for both zones exceed the
maximum available amount of power, the power man-
] grant a boost of
Display
[ P ]
[ 9 ] to [ 0 ]
Display
[ P ]
[ and
P ]
[ P ] to [ 0 ]
[ 9 ] to [ 0 ]
agement function is automatically reducing the power
from one of these zones. The display of this zone is first
blinking; the level is then automatically reduced to the
highest suitable position.
Heating zone The other heating zone:
selected (example: power level 9)
[ P ] is [ 9 ] goes to [ 8 ] and blinks
displayed
It is possible to activate the booster function (or double
booster) on several cooking zones at the same time, for
this it is necessary to use the zones in a discriminant
way (A-B).

4.2.5 Timer

The timer is able to be used simultaneous with all heat-
ing zones and this with different time settings (from 0 to
999 minutes) for each heating zone.
Setting and modification of the cooking time:
Action Control panel
Select the slide on the "SLIDER"
power level
Select the- Press simultaneous-
Timer ly key [ - ] and [ + ]
from the timer until the
desired display is on
Decrease Press key [ - ] from the
the time timer
Increase the Press key [ + ] from the
time timer
After a few seconds, the [ min ] display stops with blink-
ing. The time is confirmed and the timer starts.
To stop the cooking time:
Action Control panel
Select the Press simultaneously key
Timer [ - ] and [ + ]
from the timer until the
desired display is on
Stop the Press key [ - ] from the
time timer
If several timers are activated, repeat the process.
Egg timer function:
Egg timer is an independent function. It stops as soon
as a heating zone starts up. If the egg timer is on and
the hob is switched off, the timer continues until time
runs out.
Display
[ 1 ] to [ P ]
Timer dis-
play on
[ 60 ] to 59,
58...
Time in-
crease
Display
Timer dis-
play on
[ 000 ]
EN 39