Pkm DW 14-7FI A++ Bedienungsanleitung Seite 68

drained. In such a case you must refill the detergent container.
1. Open the door and press the current programme selection for at least 3
seconds.
2. Set the new programme.
3. Close the door.
When you open the door while the appliance is operating, the appliance will stop
operating. The display indicates the code E1. When you close the door again, the
appliance will start operating after 10 seconds.
The 6 control lights indicate the status of the appliance.
a) All lights are off = stand-by mode.
b) One light is on = the relevant programme is running.
c) One light flashes = Pause - mode.
How to use 3in1 tabs
1. 3in1 detergents contain a combination of detergent, rinse aid and water
softener.
2. The 3in1-programme is an additional function and can be operated in
combination with one of the following 3 programmes only: intensive, eco or
light.
3. Check that the water hardness of your water supply meets the information given
on the packaging of the 3in1 detergent.
4. Strictly observe the instructions of the manufacturer of the 3in1 detergent.
5. If a problem occurs when using a 3in1 product for the first time, contact the
info-hotline of the manufacturer of the 3in1 product.
6. When using a 3in1 product, the indicators for the rinse aid and water softener
are no longer useful. It may be helpful to set the water hardness to the smallest
possible value.
How to select the 3in1 programme
1. Press the ON/OFF button and select the 3in1 programme by pressing the
3in1 button until the 3in1 indicator flashes.
2. The 3in1 programme is available after you pressed the 3in1 button and the
3in1 indicator is on.
How to cancel the 3in1 programme
1. Follow the instructions in HOW TO CHANGE A PROGRAMME. If you
want to operate the appliance with a standard detergent system again, then
proceed as follows:
a. Fill the water softener and the rinse aid container.
68