Installation; Installation In Floor Slab - Kessel 28300 Bedienungsanleitung

Important:
Pump station is to be installed in frost-free
and dry area. Do not immerse cable ends
into the water while installation and moun-
ting. Electrical plug connection is to be
protected from moisture. In case of floo-
ding danger the mounting of the electrical
plug connection should be executed in an
area where there is no danger of flooding.
Prior to installation of KESSEL pump sta-
tiontion qualift ® F, all parts must be
checked upon loss during transport.
2.1 Installation in slab:
The pump box is to be levelled up horizontal-
ly on a granular subbase.
Insert the enclosed rubber gasketed seal into
the recessed gasket area, grease it and
mount the upper section. The telescopically
upper section allows a continously variable
adjustment of the pump station Aqualift F into
already existing installation depth. Ground
falling gradient can be levelled out until up to
5°. An adjustment of the cover, p. e. the tile
pattern is possible (picture 2).

2. Installation

CAUTION: After final adjustment cut-outs
have to be fixed at the upper section espe-
cially in the area of cable bushing and
where additional inlets were added (pictu-
re 3).
3
After successful water proof check of all exi-
sting piping the vessel can be poured into con-
crete bed.
2
7
2.2 KESSEL-Pump Station qualift
depressed installation into the slab
(with extension Article # 83070)
Depending on installation depth one or two ex-
tensions between upper section and connec-
tor may be used. The gaskets are to be grea-
sed accordingly. Thereby the drain pipe must
be shortened according to the level adjust-
ment.
Installation of covers with selectable sur-
face:
For the covers with choice of surface there is
the possibility of fixing tile flooring or natural
stone into the cover. This way you can fit the
flooring to the room. For tile fixing we recom-
mend products by PCI, Schomburg, Deiter-
mann. To achieve an unproblematic work-
manship we recommend the following:
® F for