Installation Of Pump - Kessel 28300 Bedienungsanleitung

The venialtion tube must be in-
stalled with a constant increa-
sing slope to the control unit.
e) Ventilation vent
Ventilation vent shall be provided at all
times.
A ventilation pipe must be installed with this
system. For this pumping system it must be
installed at a minimum of a nominal width DN
70. To avoid unpleasant odour it must be gui-
4
2. Installation
ded across the roof.
A fixture access is
provided. This is
sealed by a socket
plug. Remove it for
installation purpo-
ses. For the Tronic-
option it is recom-
mended to install
the optical sensor
prior to the installa-
max. deepth 4 cm
tion of the fixture
vent.
f) Alarm device
For installation of the float switch version the
alarm device is strongly recommended. Her-
ewith, failures during operation will be indica-
ted, p. e. an increased water level caused by
failure of the pump. In addition a remote con-
trol signaller must be installed.
2.4 Installation of the pump:
To avoid damage during transporting the
pumps are packed separately. Check
9
whether the sewage station is free of solid
contamination and building material. Whe-
reas this is not the case the complete equip-
ment is to be cleaned. Prior to installtion clea-
ning of all sealed surfaces is essential. Insert
the pump into the pump slab and fix it with the
help of the two lock staples (safety hook). Fix
and lock the rotatable connection with the
one-hand-fastener (see picture 5). Assure a
back-up of 1 m minimum for the length of the
tube for installation to allow to lift out the
pump and put it on the tile flooring for main-
tenance service.
Caution: Check after installation
whether the pump is mounted sta-
tionary. As there are existing two versi-
ons, please follow further proceedings.
a) Aqualift F Mono with float
®
After installation the float has to be inserted
into the separate opening. Pull the cable to-
gether with the plug through the cable con-
duit. The unit is ready for operation as soon
as the power supply is available.