Kessel 28300 Bedienungsanleitung Seite 34

b) Aqualift F Tronic/Duo
®
Pull the transparent tube of the already in-
stalled pressure sensor through the cable
5
conduit. Pay attention to a unbuckled and
permanent rising of installation. In addition
the optical sensor (alarm device) is to be ins-
erted into the designated opening. Hereby
the purple sealing plug is to be removed.
The Tronic version is ready for operation as
soon as the cables are connected to the con-
trol unit according to the instructions given in
the manual.
Refill the vessel with water and proof check
2. Installation
the functions of the floating switch respec-
tively the pressure sensor.
2.5 Installation in concrete slabs sub-
ject to high groundwater / moisture
(gasket set Article Number 83023)
In case of installation in concrete slabs sub-
ject to high groundwater / moisture the KES-
SEL wastewater pumping station can be ea-
sily and unproblematically sealed. Herewith a
seal sheeting is clamped between the coun-
terflange made of polymer and at the inte-
grated compression seal flange of the carrier
and bolted with the attached screws. Any on
site used sealing foil is acceptable. For in-
stallation into a water resistant sump pan
KESSEL offers an additional matching sea-
ling sheet made out of natural latex material
with counterflange. Here, the drill-holes for
bolting are already stamped out. (Article
Number 83023, see picture 6).
If it is necessary to make an opening for ex-
ample into the concrete sump pan for the ac-
cess of the inlet, cable conduit access and so
on these interpenetrations must be executed
so watertightness is guaranteed.
counterflange
seal sheeting
6
10
Gasket set
(83023)
compression
seal flange