Elite volare force mag Bedienungsanleitung Seite 14

EN
•
Install the remote regulation shifter on the han-
dlebar as shown in illustration 13, make sure that
the regulation cable is inside the trainer base (Fig.
14).
•
If the handlebar diameter is such that the clamp of
the remote regulation shift cannot be tightened,
either one or both of the rubber linings on the clamp
may be removed, allowing it to be adapted to larger
diameters (Fig.15).
• Now you may begin training. Resistance can be
adjusted from a minimum (value 1) to a maximum
(value 5).
14
BICYCLE REMOVAL
•
Free the bicycle's tire from the resistance-unit's
drum by pushing the Spring Plate (H) down with
the palm of your hand until the Spring Plate
mechanism reaches it's locked position (Fig. 5).
•
Remove the remote regulation shifter from the
handlebar.
•
Loosen the handle (G) by pushing the locking
ring (F) against the handle (G) (Fig. 3).
•
While holding the bicycle, loosen the locking
axle (E) rotating the handle (G) until the bicycle is
free. Then remove the bicycle.
•
Release the Spring Plate (H) lock by pushing
13
down on the Spring Plate with the palm of your
hand and, with your fingers, pull gently upwards
the Spring Plate (H) release (Fig. 11).
DO NOT LEAVE THE TRAINER
UNATTENDED WITH THE SPRING
PLATE MECHANISM IN LOCKED
14
•
Carefully wind the remote regulation shifter of
the trainer resistance unit around the relevant
hooks located on the frame.
•
Keep people, children and animals away from
the roller during use, since the moving and rota-
ting parts of the roller and the bicycle can cause
damage in case of contact.
•
Before starting training, position the trainer in a
dry place, away from potentially hazardous objects
(furniture, tables, chairs, etc.) in order to avoid any
risk of inadvertent or accidental contact with
them.
•
Do not brake when using the trainer, as this can
permanently damage the roller and the tyre.
•
The resistance unit may warm-up while in use.
Let it cool down before handling it and touching
the flywheel.
15
•
There are no user serviceable parts.
The warranty is void if opened or tampered for any
reason.
•
The frame is intended for single-rider bicycles only.
•
Control the security and the stability of the
(DOWN) POSITION!
ATTENTION