Schaltplan
Wiring diagram
2
1
1. Elektronik
2. Heizelement
3. Sicherheitsdruckbegrenzer SDB
4. Klemmleiste
5. Sicherheitstemperatur begrenzer STB
1. Electronic circuitry
2. Heating element
3. Safety pressure cutout
4. Terminal strip
5. Safety thermal cutout
7. Elektroanschluss
Nur durch den Fachmann!
Zu beachten sind:
• VDE 0100
• EN8062
• Bestimmungen der örtlichen
Energie und Wasserversorgungs
5
unternehmen
• Technische Daten und Angaben auf
Typenschild
3
• Gerät an den Schutzleiter
4
anschließen!
Bauliche Voraussetzungen
• Das Gerät muss dauerhaft an fest
verlegte Leitungen angeschlossen
werden. Das Gerät muss an den
Schutzleiter angeschlossen werden.
• Die Elektroleitungen müssen sich in
einem einwandfreien Zustand befin
den und dürfen nach der Montage
nicht mehr berührbar sein.
• Installationsseitig ist eine allpolige
Trennvorrichtung mit einer Kontakt
öffnungsweite von mindestens
3 mm pro Pol vorzusehen (z.B. über
Sicherungen).
• Zur Absicherung des Gerätes ist ein
Sicherungselement für Leitungsschutz
mit einem dem Gerätenennstrom
angepassten Auslösestrom zu montie
ren.
Lastabwurfrelais
Beim Anschluss weiterer Drehstrom
geräte kann ein Lastabwurfrelais für
elektronische Durchlauferhitzer (CLAGE
Art.Nr. 82250) an den Außenleiter L
angeschlossen werden.
LCD Beschreibung
Normaler Betrieb,
0
Werkeinstellung
Betrieb mit normalem
1
Lastabwurfrelais
Betrieb mit empfindlichem
2
Lastabwurfrelais
Zum Ändern der Betriebsart rufen Sie
bitte zunächst das SetupMenü auf:
7. Electrical connection
Only by a specialist!
Please observe:
• The installation must comply with
• The rating plate and technical speci
• The unit must be earthed!
Structural prerequisites
• The appliance must be installed via a
• The electric wiring should not be
• An allpole disconnecting device (e.g.
• To protect the appliance, a fuse ele
Load shedding relay
If further threephase appliances are con
nected, a load shedding relay designed
for electronic instantaneous water heat
ers (CLAGE no. 82250) can be connected
2
to phase conductor L
A special operating mode must be selec
ted on the appli ance for this purpose.
To change the operating mode, call up
13
current IEC and national local regu
lations or any particular regula
tions, specified by the local electric
ity supply company
fications
permanent connection. Heater must
be earthed!
injured. After mounting, the wiring
must not be direct accessible.
via fuses) with a contact opening
width of at least 3 mm per pole should
be provided at the installation end.
ment must be fitted with a tripping
current commensurate with the nomi
nal current of the appliance
.
2
LCD Description
Normal operation,
0
manufacturer's setting
Operation with normal
1
load shedding relay
Operation with sensitive
2
load shedding relay
CLAGE