DSX SERVOTRONIC MPS
®
7. Elektroanschluss
Drücken Sie gleichzeitig die SetupTaste
und die InfoTaste
für mindes tens
3 Sekun den, die Anzeige bestätigt mit
»Setup«.
Nach siebenmaligem Drücken der Pfeil
taste
erreichen Sie das SetupMenü
für den Lastabwurf. Ein Drücken der
SetupTaste
aktiviert den Verstell
modus des Parameters »Last abwurf«, die
Anzeige blinkt. Sie können nun mit den
Pfeiltasten
und
zwischen den Ein
stellungen »0«, »1« und »2« wählen. Ein
erneuter Druck auf die SetupTaste
speichert den neuen Parameter wert.
Mit der Info Taste
gelangen Sie wie
der in die Normalanzeige.
Zunächst ist die Betriebsart »1« zu wäh
len und die Funktion des Last abwurf
relais bei kleiner Geräteleistung (35 Grad
Sollwert und geringe Wasser menge) zu
prüfen. Kommt es zu einem Flackern des
Abwurfrelais, so muss die Betriebsart »2«
gewählt werden.
14
7. Electrical connection
the setup menu first:
Press the setup key
and the info key
simultaneously for at least 3 seconds,
the display confirms by "Setup".
After pressing the arrow key
times, you reach the setup menu for the
load shedding. The setup mode of the
parameter "load shedding" is activated
by pressing the setup key
is flashing. You can now select between
mode "0", "1" and "2" with the aid of
arrow key
and
. A new pressing on
the setup key
will store the new
parameter value.
You will get back to the normal display
by pressing the info key
.
Operating mode 1 must be selected first,
thus to check the correct operation of
the load shedding relay at low appliance
output (35 degree celsius setpoint and
low water flow rate). Mode "2" must be
selected if the load shedding relay flick
ers.
seven
, the display