Hameg HM8015 Handbuch Seite 31

Voltages higher than those values may
only be applied by qualified personnel who
know the applicable safety rules.
Disconnect the input voltage before unp-
lugging the safety connectors at the input
terminals. Disregarding this can lead to
accidents, in the worst case there may be
danger of life!
If objects specified for safety class I are
connected to the OUTPUT
without an isolation transformer the
safety earth must be separately connected
to the object under test, otherwise there
is danger of life.
The safety plugs may become quite hot
at high currents.
STOP STOP
The upper two terminals (red) are inter-
nally connected. Do not apply any voltage,
this would be short-circuited
The shunt is connected internally between
the two lower (black) terminals. Do not
apply any voltage either because this
would practically short-circuit it.
Measuring circuit fuse
The measuring circuit of the HM8015 is protected
by 2 fuses. These fuses are not accessible from
the outside. In case of a blown fuse the
instrument has to be sent in for repair. A change
of the fuses by the customer is not permitted.
terminals
S a f e t y i n s t r u c t i o n s
Subject to change without notice
31