Storing The Device; Maintenance And Care; Troubleshooting - Kärcher HD 13/35-4 Cage Betriebsanleitung

Do not transport any articles on the ap-
–
pliance during the lifting process.
The appliance must only be transported
–
by properly trained crane personnel.
Do stand stand below the load.
–
Ensure that no persons are present in
–
the immediate vicinity of the crane.
Do not leave the appliance on the crane
–
unattended.
Safety check
 Check all screws of the appliance for
tightness; retighten if necessary.
When transporting in vehicles
When transporting in vehicles, secure the
appliance according to the guidelines from
slipping and tipping over.

Storing the device

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
Maintenance
Safety inspection/ maintenance contract
You can sign with your dealer a contract for
regular safety inspection or even sign a
maintenance contract.
Please take advice on this matter.
Before each use
 Check mains cable.
The mains cable should not have been
damaged (risk of electrical shock). A
damaged mains cable must be re-
placed immediately by an authorised
Customer Service Engineer or an elec-
trician.
 Check the high pressure hose for dam-
ages (risk of bursting).
Please arrange for the immediate ex-
change of a damaged high-pressure
hose.
 Check oil level from the oil level display
of the high pressure pump.
Please contact Customer Service im-
mediately if the oil is milky (water in oil).
 Check appliance (pump) for leaks.
3 drops per minute are permitted and
can come out from the lower side of the
appliance. Call Customer Service if
there is heavy leakage.
Weekly
 Clean filter at the water connection.
 Check tire pressure of wheels (refer to
"Specifications").
After 50 operating hours
 Change oil in the pump.
monthly or after 500 operating hours
Change the oil in the high pressure pump.
 For oil type refer to technical specifica-
tions.
 Turn out the oil drain screw.
 Drain the oil in a collection basin.
 Screw in oil drain plug.
 Fill in new oil slowly until the centre of
the oil level display.
Note
Air pockets must be able to leak out.

Troubleshooting

You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.
Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
Warning
Repair works may only be performed by the
authorized customer service.
– 7
EN 21