Indicator lamp
The indicator lamps display the operating
states (green) and interruptions (red).
Reset:
Set the appliance switch to "0".
Wait for a while.
Set the appliance switch to "I".
Operating status display
Continuous green:
The appliance is now ready for opera-
–
tion.
1x blinking green:
Operational readiness has expired after
–
30 minutes.
The appliance has switched off after 30
–
minutes of continuous operation (safety
if the high pressure hose bursts).
Fault indication
Continuous red light:
Electrical problems in appliance
–
Pull out the mains plug.
Call Customer Service.
1x blinking red:
High pressure side is leaky
–
Check high pressure hose, hose con-
nections and hand spray gun for leaks.
2x blinking red:
Engine overload/overheat
–
Set the appliance switch to "0".
Allow device to cool down.
Set the appliance switch to "I".
Water pressure is too low
–
Ensure adequate water line pressure.
3x blinking red:
Fault in the voltage supply
–
Check main connections and mains
fuse.
4x blinking red:
Power consumption is too high
–
Call Customer Service.
22
Appliance is not running
No power
–
Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the socket.
Check the mains connection cable for
damages.
Indicator lamp is blinking green
–
Operational readiness period has ex-
pired. Switch on/off the appliance
again.
The water shortage fuse (option) was
–
triggered due to low water inlet pres-
sure.
The indicator lamp "lack of water" will il-
luminate.
Check water inlet pressure, minimum
value see "Specifications".
Turn the device switch to "0" and turn
on again to restart the system.
Motor overloaded/ over-heated or elec-
–
trical circuit breaker or winding protec-
tion switch has got released.
Switch off appliance and let it cool
down. Remove the cause of the prob-
lem. Turn on the appliance again.
Device is not building up pressure
Wrong nozzle
–
Check nozzle for correct size (see tech-
nical specifications).
Flushed the nozzle.
–
Clean/ replace nozzle.
Filter is dirty.
–
Clean filter at the water connection.
Unscrew the filter casing, remove the
filter, clean it and replace it.
Air within the system
–
Appliance ventilation:
Unscrew the nozzle. Switch on the ap-
pliance and let it run until the water ex-
iting from the spray pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.
Pipe inlets to pump are leaky or blocked
–
Check all supply lines to the pump for
leaks or blockages.
– 8
EN