Interrupting Operation; Finish Operation; Frost Protection; Transport - Kärcher HD 13/35-4 Cage Betriebsanleitung

Set working pressure and flow rate
 Pull the lever on the handgun.
 Set the working pressure and quantity
by turning the pressure/ quantity regula-
tion mechanism at the pump unit.
The working pressure can be read from
the manometer.

Interrupting operation

 Release the lever on the trigger gun.
The appliance switches off after 30 sec-
onds.
 Use the safety catch to secure the
handgun lever.
 Store the hand spray gun and spray
pipe in the accessory mount.

Finish operation

 After operating the water using saline
water (sea water), open the hand spray
gun and rinse the appliance for at least
2 - 3 minutes using tap water.
 Release the lever on the trigger gun.
 Set the appliance switch to "0".
 Shut off water supply.
 Activate hand spray gun until device is
pressure less.
 Use the safety catch to secure the
handgun lever.
 Remove the water inlet hose from the
appliance.
 Pull out the mains plug.
 Stow away the mains cable, the high-
pressure hose and accessory at the ap-
pliance.

Frost protection

Warning
Risk of damage! Freezing water in the ap-
pliance can destroy parts of the appliance.
Store the appliance in a heated room dur-
ing winter or empty it. During longer breaks
in operation, it is advisable to pump in anti-
frost agents into the appliance.
20
Drain water
 Screw off water supply hose and high
pressure hose.
 Blow through machine with com-
pressed air.
Flush device with anti-freeze agent
Note
Observe handling instructions of the anti-
freeze agent manufacturer.
 Pump in conventional frost protection
agents through the appliance.
A certain corrosion protection is achieved
with this as well.
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Push the push handle down and push
the appliance.
Transport by crane
 Connect the lifting device in the center
of the strut to load by crane.
Safety information about cranes
Danger
Risk of injury due to machine dropping.
Adhere to the local accident prevention
–
guidelines and safety notes.
Check the appliance for crane loading
–
for damage prior to each transport by
crane.
Check the lifting unit for damage prior to
–
each transport by crane.
Only lift up the appliance by this mech-
–
anism when loading by crane.
Do not use stop chains.
–
Protect the lifting device from inadvert-
–
ent load release.
Remove the spray pipe with hand spray
–
gun as well as loose articles prior to
transporting by crane.
– 6
EN

Transport

Driving