Setting The Spray Jet Width; Setting The Amount Of Material; Setting The Amount Of Air; Setting The Ascending Feed Pipe - WAGNER FineCoat 8800 Betriebsanleitung

Setting the spray jet width (fig. 4)
Adjusting ring
Turn to the right = wider spray jet
Turn to the left = narrower spray jet
Note:
The adjusting ring does not fasten the air cap!
4
Setting the amount of material (fig. 5)
Set the amount of material by turning the material adjustment
knob.
Turn to the left = more material
Turn to the right = less material
5
GB
Setting the amount of air (fig. 6)
The correct setting for the amount of air is decisive for the
atomization and formation of paint mist.
6
Maximum
Minimum

Setting the ascending feed pipe

Spraying object lying on floor (fig. 7)
Turn rotating lever clockwise as far as it will go.
7
Spraying object over head (fig. 8)
Turn rotating lever anti-clockwise as far as it will go.
8
16
Minimum