Funtions And Cleaning; Initial Start-Up - Zummo Z40-LM Bedienungsanleitung

6. FUNTIONS AND CLEANING


It is advisable to turn the machine off at the mains before starting any cleaning processes.

Do not wash the machine using water jets and/or water at high pressure.

We recommend at least one daily clean of the components in the juice squeezing zone (cups,
squeezing balls, drip tray, filter, blade and cover), following the cleaning instructions.

The product provided by the machine is citrus juice with a pH level of 4.5, which is not
considered as being a potentially dangerous foodstuff.

6.1. INITIAL START-UP


Depending on the size of the oranges to be squeezed, select the correct size of cup and ball
and the fruit classifier for the basket and position the lower fruit classifier correctly (Fig. 8a-
8b). See the section on ACCESSORIES.

Fit all the parts in their correct positions. See assembly in the section on CLEANING. If you
have a service model (with a tank), fit the support on the base of the machine (Fig. 9).

Do not place your hand into the basket while the machine is operating (Fig. 10).

Z40 Model or Z40 Service Model:
- Once the machine is switched on, the display will show either a number between 1 and
999 or the letter C. The number indicates the quantity of fruits to be squeezed, while the
letter C sets the machine to squeeze continuously for approximately 30 minutes.
- To st the number of oranges to squeeze, press the SELECT button repeatedly to increase
the number (from 1 to 999, followed by the letter C. (1,2,3, ..........997,998,999, C,1,2,3....).
Alternatively, press and hold the SELECT button for 2 seconds and the number will
decrease. Continue until you visualize the wanted number.
- The selected number will be stored on the display after the first complete squeeze cycle
is finished. The number will be stored even if the machine is switched off. You may
change the number repeating the complete number selection process.
- Press the ON button to start squeezing. During the process, the display will show the
remaining amount of fruits to be squeezed. If you wish to repeat the process, simply
press ON. To stop the process, press the STOP button.

Z40 Self-service Model:
- Once the machine is turned on, the screen displays an orange icon. This means that the
machine is ready to squeeze fruit.
- When you press the tap down, the juicer will start working and the screen will display a
Clock icon and the word "Run", while the machine is working. In order to stop the
machine, just release the tap.
29