Qualifications And Training Of Employees; Dangers Resulting From Non-Adherence To The Safety Information; Safety-Conscious Operation; Safety Information Regarding Maintenance, Inspection And Installation Work - Oase WECS II 512 DMX/02 Gebrauchsanleitung

- GB -
8.4

Qualifications and training of employees

Ensure that installation personnel have the required technical qualifications.
►
Also ensure that all operating personnel are sufficiently qualified.
►
Ensure that maintenance work is only performed by personnel authorised for this purpose, e.g.
►
specialists of OASE GmbH or personnel with suitable training.
8.5

Dangers resulting from non-adherence to the safety information

WARNING
Please note that OASE GmbH assumes no liability for damage, downtimes or malfunctions resulting from
non-adherence to this installation and operating manual.
By ignoring or not adhering to all of the safety information contained in this manual, you could endanger
people, the environment and the system of this unit.
For example, non-adherence to the safety information contained in this manual can lead to the following
dangerous occurrences:
A malfunction of important features of this unit
►
Hazards for persons due to electric shock
►
8.6

Safety-conscious operation

As a user of this unit, ensure that you follow all safety information contained in this manual. Follow the
accident prevention regulations at all times. If the unit is used in a location where internal regulations,
operating and safety instructions apply, ensure that these regulations and instructions are also adhered
to.
8.7

Safety information regarding maintenance, inspection and installation work

It is the owner/user's responsibility to ensure that all maintenance, inspection and installation work is
carried out by authorised and qualified personnel who have read and understood this manual.
Only carry out maintenance work on this unit when the unit system is switched off.
Ensure that no pressure is applied to the unit and it is disconnected from the power supply (voltage-free)
before carrying out maintenance or repair work.
Ensure that small malfunctions are immediately rectified by authorised personnel to avoid possible future
damage, malfunctions and/or downtimes of the unit system.
Certain maintenance work may require safety barriers to be removed and/or deactivated. If this is the
case, ensure that all safety and protective devices/guards are re-installed and/or reactivated after
completing the maintenance work. Before re-connecting the unit, adhere to all information contained in
chapter 18.1 "Start".
8.8

Optional retrofitting and production of spare parts

Changes or modifications to the device are only permitted after consultation with the manufacturer.
Original spare parts and accessories approved by the manufacturer provide safety. We wish to stress that
all parts and accessories not supplied by OASE GmbH have neither been tested nor approved by OASE
GmbH. For this reason, the installation and/or use of such products can, under certain circumstances,
negatively affect the specifications for the device. This could also lead to restrictions of the active and/or
passive safety of the device. OASE GmbH assumes no liability for damage resulting from the use of parts
and accessories other than original OASE parts.
30