Enabling Or Disabling The Scrolling And Tapping Features - Sony VGP-BRMP10 Bedienungsanleitung

3
Note
After use, set the power switch on the controller (page 7) to OFF.

Enabling or disabling the scrolling and tapping features

You can enable or disable the touchpad's scrolling and tapping features
(page 16). The scrolling feature is enabled and the tapping feature is
disabled by default (factory settings).
Note
If the power switch on the controller is set to ON, set it to OFF once, then follow the steps
below.
1
GB
14
Note
If you operate the Previous Slide button/Next Slide button and touchpad at the same
time those buttons may not work as intended while the tapping feature is activated.
Press the button so as not to touch the touchpad, or disable the tapping feature (page
14).
End a slideshow.
Press the SLIDE SHOW button.
z Hint
If nothing happens, try pressing the button again.
While pressing and holding the SLIDE SHOW button, Left
button, and Next Slide button, set the power switch to ON,
then after about 1 second, release the buttons.
Left button
Next Slide button
Power switch
SLIDE SHOW button