Sony VGP-BRMP10 Bedienungsanleitung Seite 50

Symptom
The controller does
not react to the buttons
or touchpad's
operation.
Just touching the
touchpad causes a
click.
Just sliding my finger
on the touchpad
causes scrolling.
Pressing the
CONNECT button
does not establish a
connection.
GB
22
Cause/Remedy
c In some operating environments, the usable distance
may be noticeably shorter, preventing normal
operation. In such cases, use the controller farther
away from any other devices that may be interfering
with operation.
c If the controller is too far from your personal
computer, communication is not possible. Bring the
controller and your personal computer closer together.
• You have pressed the CONNECT button while operating
the controller.
c If you have pressed the CONNECT button while
operating the controller, connection with the
personal computer will be terminated and the
controller cannot be operated. If you have pressed
the CONNECT button, turn the controller off and
back on.
• The controller may not be able to establish a connection
in environments where communications are being
conducted using wireless LAN (2.4 GHz band) or
Bluetooth products.
c We recommend using the controller in a location
relatively free of influence from wireless
communications.
c Disconnect any Bluetooth products other than this
controller.
• You are operating the touchpad using the pad of your finger.
c Intended operation may be difficult with the pad of
your finger. We recommend lightly sliding the tip of
your finger on the touchpad. Operation may also be
adversely affected if your fingertip is sweaty.
• You have set the pointer speed set too low.
c Follow the instructions in "Adjusting the pointer speed"
(page 15) to adjust the pointer speed.
• The tapping feature is enabled.
c You can disable tapping. See "Enabling or disabling
the scrolling and tapping features" (page 14) for
details.
• The tapping feature is enabled.
c You can disable scrolling. See "Enabling or
disabling the scrolling and tapping features" (page
14) for details.
c If the power switch on the controller is set to OFF,
communication with the personal computer is not
possible. Check the power switch setting on the
controller.