Sony VGP-BRMP10 Bedienungsanleitung Seite 52

Symptom
The Previous Slide
button or Next Slide
button does not work
properly.
When I am using the
controller, the display
goes dark or the
personal computer
enters standby mode.
The personal
computer does not
recover from monitor
standby mode.
The personal
computer does not
recover from standby
mode with the
controller, or it takes a
long time.
The controller does
not operate smoothly
after recovering from
the standby mode of
the personal computer.
The controller does
not connect when I
turn it off and back on.
The controller does
not connect after
recovering from
personal computer's
standby mode or the
controller's power-
saving mode.
GB
24
Cause/Remedy
• The tapping feature is activated.
c Disable the tapping feature. For details, see
"Enabling or disabling the scrolling and tapping
features" (page 14).
• The personal computer enters standby mode even
while the controller is in use.
c Change the power management settings for the
personal computer to prevent it from entering
standby mode. For details, refer to the manuals
provided with your personal computer.
c Touch the touchpad or press any key on the
keyboard of the personal computer to recover from
standby mode.
c Touch the touchpad or press any key on the keyboard
of the personal computer to exit this mode.
c Press any key or the power button on the keyboard of
the personal computer .
c Deactivate the Bluetooth connection, wait a few
seconds, and then re-establish connection.
c Set the power switch to OFF, and set it to ON again
after a while. If the controller does still not connect,
check the following.
• The security level of the Bluetooth Utility software is
set to High.
c If you can set the security level using the Bluetooth
Utility software, in the Options dialog, on the
Security tab, set the Bluetooth Security level to
other than High (Medium, Standard, or Low).
• The software is set to Don't allow connections.
c If you can set the connection mode using the
Bluetooth Utility software, in the Device Properties
& Security dialog, on the Security tab, set the
Connection Mode to Allow connections.