Replacing The Batteries - Sony VGP-BRMP10 Bedienungsanleitung

Note
To prevent battery fluid leaks and damage, observe the following precautions.
• Insert the batteries with the correct + – orientation.
• Do not charge dry cell batteries.
• Do not use old and new batteries together. (Doing so may cause the battery fluid
to leak. It can also prevent the controller from operating.)
• Do not use different types of batteries together.
• If the controller will not be used for a long time, remove the batteries.
• If a battery fluid leak occurs, carefully wipe the battery compartment, and insert
new batteries.
• To prevent accidental operation, be careful not to press any buttons when

replacing the batteries.

4
Close the battery compartment cover.
z Hint
The battery will last approximately 14 hours in continuous use (when using alkaline
batteries). Check the controller's POWER lamp if the pointer or button becomes
unresponsive. If the POWER lamp is flashing yellow, replace the batteries. When not
using the controller, set the power switch to OFF.
Replacing the batteries
The POWER lamp flashing yellow indicates that the battery life is running low. Replace
the batteries when this occurs.
Continued on next page
GB
9