Serielle Schnittstelle
Serial interface
Datenausgabe auf PC oder Terminal
Nur in der Betriebsart "pH-" oder "mV-Messen" möglich.
Schnittstellenkabel AK540/B
anschließen.
PC und pH 540 GLP einschalten.
Terminalprogramm am PC starten.
Konfigurieren mit nachfolgenden
Einstellungen.
Übertragungsdaten:
Baudrate
Datenbits
Stoppbits
Handshake
maximale. Kabellänge
Zeichensatz
Starten der Protokoll- und Datenausgabe
am pH 540
Die Ausgabe von Kalibrier- und Meßwerten sowie
Protokollen erfolgt analog zur Druckausgabe, das
Empfangsgerät ist in diesem Fall jedoch ein
PC/Terminal:
dann / then
bis / until
Funktion zur Ausgabe von Protokollen auf
das
angeschlossene Empfangsgerät.
BA11102/05.00/Pla/pH540GLP-4
Parität
Hardware (RTS/CTS)
ASCII-Zeichenketten (IBM-Zeichensatz),
Trennung durch Leerzeichen
ASCII strings (IBM font), separated by blanks
Data output on PC or terminal
Only possible in operation mode "pH" or "mV
measurement".
Transmission data:
4800
8
1
keine / none
15 m
Start of output of protocol and data on the
pH 540
Output of calibration and measured values as well
as protocols is made analogously to the printing, the
receiver, however, is in this case a PC/terminal.
Function for protocol output to the connected
receiver.
Connect interface cable AK540/B.
Switch PC and pH 540 GLP on.
Start the terminal program on the PC.
Configuration with the following
settings.
Baud rate
Data bits
stop bits
Parity
Handshake
maximum cable length
Font
25