Trouble-Shooting; Possible Cause; Disassembly And Disposal; Gurantee And Aftersales Service - G-U ELTRAL KS 30/40 EASY TR Montage- Und Bedienungsanleitung

Assembly and operating instructions
ELTRAL KS 30/40 EASY TR
Chain drive

13 Trouble-shooting

Installers or end-users must not repair a faulty motor themselves. Professional repair can only
be carried out by the manufacturer. If you open the motor or manipulate it in any way, the war-
ranty shall be null and void.
Therefore you should replace a faulty motor or have it repaired
º œ
If the motor stops running, check whether the limit position switch is activated.
º œ
In case any problems arise while installing or operating the drive, please consult the following
trouble-shooting table:
Problem
Drive not
functioning
If the motor does not respond to actuation by wall switch, have the power supply checked by a
qualified electrician.

14 Disassembly and disposal

Dismantling
DANGER
To disassemble the appliance follow the mounting instructions in reversed order omitting the
adjustments.
Disposal
Motor components
Note!
º
Dispose of the parts in accordance with the local disposal regulations.
º œ

15 Gurantee and aftersales service

All deliveries are made on the basis of our General Terms and Conditions
The guarantee complies with the legal regulations and is valid in the country where the motor
was purchased.
The guarantee covers material and manufacturing defects occurring under normal stress.
Guarantee and liability claims in view of personal injury and damage to property are excluded, if
the latter have occurred as a result of
• Inappropriate use of the motor.
• Improper installation, commissioning, operation, maintenance, and repair of the motor.
• Operation of the motor with faulty, incorrectly fitted or non-functional safety and protection devices.
• Failure to observe the advice given in the assembly and operating instructions.
• Unauthorised structural modification of the motor.
26

Possible cause

• Connecting cable unplugged or
wire(s) loose.
• Power supply unit in the drive dam-
aged not providing low voltage.
Observe the safety advice under „Mounting the device" !
• Aluminium
• Iron
Solution
Check the fault current circuit
º œ
breaker or safety switch.
Check all electrical connec-
º œ
tions of the drive.
Exchange the drive.
º œ
Plastic
●
Copper
●
Zinc
●