AERMEC FCXI 20 Installationsanleitung Seite 23

FCXI_AS_U
Before installation, check the techni-
cal spaces required :
for installation;
•
for connection to the hydraulic cir-
•
cuits and to any valve;
for connection to the power supply;
•
for connection of an external panel
•
flush to the unit (when provided for)
for the set up of the flow and expul-
•
sion ducts (for models requiring it);
for draining condensation;
•
for cleaning the filters;
•
for cleaning internal components
•
and for maintenance.
WARNINGS ON USE
ATTENTION: The appliance can be
used by children over the age of 8
and by people with reduced phys-
ical, sensory or mental capabilities
or without experience or necessary
knowledge, as long as they are su-
pervised or have been instructed on
the safe use. Of the appliance and
on the understanding of the dangers
inherent to it. Children must not
play with the appliance. The cleaning
and maintenance to be carried out
by the user must not be carried out
by children without supervision.
DO NOT USE THE FAN COIL
IMPROPERLY
The fan coil must not be used to
breed, deliver and raise animals.
AIR OUT THE ROOM
Periodically air out the room in which
the fan coil has been installed; this
is particularly important if the room
is occupied by many people, or if
there are gas appliances or sources
of odours.
ADJUST THE TEMPER ATURE
CORRECTLY
Room temperature should be regu-
lated to ensure maximum comfort,
IFCXIIJ 1501 - 5386400_00
particularly for the elderly, infants
and invalids. Prevent temperature
fluctuations between indoors and
outdoors greater than 7°C during
summer.
Excessively low temperatures during
summer involve higher electrical
consumption.
DIRECT THE AIR FLOW COR-
RECTLY
Air delivered by the fan coil must not
be directed onto people. Even if the
air temperature is higher than the
room temperature, it can cause a
cold sensation and, therefore, dis-
comfort.
DURING OPERATION
During operation, always leave the
filter mounted on the fan coil; other-
wise the dust in the air will dirty the
coil surface.
IT IS NORMAL
When in cooling mode, water vapour
can come out of the fan coil air flow.
When in heating mode, a slight hiss-
ing sound can be heard near the fan
coil. The fan coil may sometimes
emit unpleasant odours due to the
accumulation of substances present
in the environment (clean the filter
more often, especially if the room is
not aired out regularly).
During operation, noise and/or a
creaking sound may be heard from
inside the device, due to the heat ex-
pansion of the elements (plastic and
metal). However, this does not mean
there is a malfunction and it does not
damage the unit as long as the inlet
water temperature remains within
the operating limits.
OPERATION ANOMALIES
In the event of operation anomalies,
power off the unit and then power
it back on and re-start the unit.
Do not try to repair the unit on your
own, as it may be very dangerous!
If the problem persists, call the Area
After-sales Service immediately.
DO NOT PULL THE ELECTRIC
CABLE
It is very dangerous to pull, step on
or crush the power supply cable or
secure it using nails or staples.
The damaged cable can cause short
circuits and injury to persons.
ELECTRICAL POWER CABLE
If the power supply cable is damaged,
it must be replaced with a new cable
of adequate section. Have the repair
made by "Qualified personnel", in
order to prevent any risk.
Do not repair damaged cables.
For the electric power supply, use
integral cables with suitable section
for the load.
DO NOT INTRODUCE OBJECTS
INTO AIR VENTS
Do not introduce any objects into the
air outlet slots.
This could cause injury to persons or
damage the fan.
EN
23