Electronic Dead Man's Control (Option) - Ammann AVH 5020 Originalbetriebsanleitung

3. Operation

3.7 Electronic dead man's control (option)

In this section only the operating and safety instructions are
described which diverge from the Standard – Operating in-
structions. Otherwise the standard operating instructions
obviously apply.
1
B8299327.ai
Machines with an emergency off switch can be supplied as an
option with an electronic dead man's control. The drive is con-
trolled over an electronic component and integrated touch sen-
sors in the handles (sensoGRIP)(1).
It is forbidden to make any changes to the system.
Deliberate or unintentional changes implemented
on the handle, the electronics or the feeder cables
Danger
can lead to a system break-down and with that en-
danger life and health.
Prior to every start-up the system must be exam-
ined for damaged cables and/or parts. Damaged
parts must be exchanged immediately. The ma-
chine may not be taken into operation with any
damaged parts.
Examine the gear switch for correct functionality
after starting up the machine by checking the
shut-down function by releasing the handle.
If, during the functionality test or machines opera-
tions the machine does not shut-down correctly
then a continuation of operation may under no cir-
cumstances be sustained and a visit to the
Ammann specialist workshop must take place im-
mediately.
Despite the installation of a dead man's control
unit a remaining danger still exists for the operator
and other persons when working with the ma-
chine. For this reason always operate the machine
with caution and consciousness of this remaining
danger.
3.7.1 Operation
• Starting the motor (Section 3.5.2).
1
B8299328.ai
• Pull emergency off switch (2).
B8299326.ai
• Hold the handle (1) tightly; the machine will drive off in the set
direction of drive.
39
2