Fuses - SWM SM 125 R 2016 Kurzanleitung

FUSES

Fuse malfunction could cause problems for the mo-
torcycle. To access the three fuses (two 15A and one
20A) proceed as follows:
Remove the saddle (1) after turning the rear fasten-
ing pin (2) anticlockwise.
Undo the screws (3) and remove the R.H. side panel
(4).
To prevent short circuits, turn the On/Off switch to
OFF, BEFORE working on the fuses.
• Do not use fuses with a different capacity
from the original one.
M-20A (cable sheath with "MAIN" or "M" written on
it):
12V locked up (system voltage), position lights;
P-15A (cable sheath with "POW" or "P" written on it):
Fuel pump, HV coil, Lambda probe heater, injector;
D-15A (cable sheath with "DC" or "D" written on it):
heater fan, rear stop, high beam, low beam, direc-
tional signals, horn, dashboard power (instrument
function viewing).
Quick RS-SM_125_MY16_ed00_11-2016_CodA000P01895.indd 17
P
M
2
A
B
D
3
1
1
4
EN - 17
15/12/16 12:40