Installation; Assembly; Tube Preparation - SOMFY Roll Up Basic 28 WireFree RTS Li-ion Anleitung

Roll Up Basic 28 WireFree RTS Li-Ion

2. INSTALLATION

1
These instructions are mandatory for the home motorisation and automation professional installing
the drive.
1
Never drop, knock or puncture the drive or immerse it in liquid.
1
Install an individual control point for each drive.

2. 1. ASSEMBLY

2. 1. 1. Drive preparation
1) Fit the crown (a) and drive wheel (b) to the
motor.
2) Measure the length (L) between the end of the
drive wheel and the head end.

2. 1. 2. Tube preparation

Cut the tube to the required length.
Deburr the tube and remove the debris.
2. 1. 3. Drive/tube assembly
1) Slide the drive into the tube. Insert the wheel
by aligning the wheel to the tube profile. Insert
the drive half way and then slide the crown
down the drive and insert it in the tube. Finally,
push the motor inside the tube.
2) Not required, but if needed, fix the tube to the
drive with self-tapping screws or steel pop
rivets depending on the dimension (L).
2. 1. 4. Mounting the tube-drive assembly on the brackets
a) Standard bracket
b) Drive plate for specific bracket
⚠
For optimal radio reception, the motor
antenna should be kept straight and should
be positioned outside of headrail (if used).
Copyright © 2017 - 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved
1
2
1
2
a b
EN
a b
3