Switch Off Parking Cooler; Advanced Settings - Webasto Cool Top Vario 10 E Bedienungsanweisung

Cool Top Vario 10 E
AUTO
Pressing the AUTO button optimally controls the set
temperature both via the compressor speed and via the fan
speed.
An activated AUTO mode is shown on the display.
After 20 minutes of operation in the AUTO mode, the
system is automatically switched into the AUTO-ECO mode.
This limits the compressor speed to 3,000 rpm.
ECO
Pressing the ECO button switches the ECO mode on or off.
In the ECO mode the compressor speed is limited to
3,000 rpm.
An activated ECO mode is shown on the display.
The ECO mode can be active in addition to the AUTO mode
(AUTO-ECO mode). In the AUTO-ECO mode, the set
temperature is optimally controlled both via the compressor
speed (maximum of 3.000 rpm) and via the fan speed.

3.3.6 Switch off parking cooler

When the parking cooler is switched off, the last target
temperature set and the last air volume set are saved. These
values are available again when the parking cooler is
switched on again.
• Press the On/Off button on the control panel or
on the remote control.
Briefly pressing the On/Off button: parking cooler
switches into the stand-by mode.
The display Stb appears. Cooling and fan are
now switched off, however can be switched on
again with the remote control.
Pressing the On/Off button for longer than three
seconds: Parking cooler switches off.
To switch on again, the On/Off button on the
control panel must be pressed.
The numbers of the temperature display flash:
The compressor was switched off by heavy
braking or driving in extreme curves. Switching
on again is carried out by pressing the On/Off
button on the unit or on the remote control.
3.4

Advanced settings

The advanced settings enable adjustment to special
environmental conditions (F1, F2, F3, F4, F5) and service
settings (F6, F7, F8).
The service menus (F6, F7, F8) should only be changed by
trained service personnel.
The following advanced settings are possible:
• F1
Setting of the switch-off limit for low battery
voltage
• F2
Setting of the switch-on limit for low battery
voltage
• F3
Setting of the minimum display brightness
• F4
Setting of the maximum display brightness
• F5
Controller offset = temperature difference
between target and actual temperature (six 1 °C
steps).
• F6
Memory for communication status of parking
cooler.
• F7
Memory for operating status of parking cooler.
• F8
Factory settings
To access the Settings menu:
1. Briefly press the On/Off button on the control
panel to access the stand-by mode.
2. Press the Temperature + and Temperature –
buttons on the control panel at the same time.
3. The Settings menu is active. F1 appears on the
display.
To change between the settings F1 to F9, press the
Temperature + or Temperature – button on the control
panel. Then activate the desired setting by pressing the
Timer button on the control panel or.
To change the value of the selected setting, press the Fan +
or Fan – button on the control panel.
3 Operation
21