Operate Parking Cooler; Switch On Parking Cooler; Set Temperature; Set Air Volume - Webasto Cool Top Vario 10 E Bedienungsanweisung

3 Operation
3.3

Operate parking cooler

3.3.1 Switch on parking cooler

• Press the On/Off button on the control panel.
In the stand-by mode, switch-on can also be
carried out with the On/Off button on the remote
control.
The last target temperature set and the last air
volume set are indicated on the display.
The parking cooler begins to operate. The
compressor is connected when needed.

3.3.2 Set temperature

The desired temperature (= target temperature) can be set
within the range between 18 °C and 28 °C in 1 °C steps:
• For a higher temperature, press the
Temperature + button on the control panel or on
the remote control.
• For a lower temperature, press the
Temperature – button on the control panel or on
the remote control.
The desired target temperature is shown on the
display.
The parking cooler cools until the desired
temperature is reached.

3.3.3 Set air volume

The desired air volume can be set in six levels:
• For a higher air volume, press the Fan + button
on the control panel or on the remote control.
• For a lower air volume, press the Fan – button on
the control panel or on the remote control.
The selected level is indicated in the display with
a corresponding number of bars.
The fan cannot be switched off with the Fan + or Fan –
buttons. To switch off the fan, change into the stand-by
mode or switch off the parking cooler.
20

3.3.4 Set air distribution (air outlet)

The air distribution can be adjusted with the two air outlets
in three types of distribution. In addition, the emitted air can
be closed at each air outlet.
CAUTION
The air outlets may not both be closed at the
same time. Otherwise, the cooling air cannot
be carried away and malfunctions can occur.
Air outlet closed
Comfort mode: large-area, uniform
distribution of cooled air
Conventional mode: large-area, concentrated
distribution of cooled air
Spot mode: concentrated, focused
distribution of cooled air

3.3.5 Set operating mode

Timer
Pressing the Timer button sets the time after which the
parking cooler switches off automatically.
The time set is shown on the display.
A maximum running time of four hours can be set.
With a running time from 0.5 hours up to 2 hours, the
running time is set in 0.5-hour steps.
With a running time from 2.5 hours up to 4 hours, the
running time is set in 1-hour steps.
Cool Top Vario 10 E
Fig. 4