Scheppach 7906100710 Originalbetriebsanleitung Seite 8

• If you are inexperienced in the use of this type of
device, you should seek out information or trai-
ning to learn how to handle it safely.
Original accessories / attachments
• Use only the accessories and attachments de-
tailed in the operating instructions. The use of
accessories other than those recommended in the
operating instructions could lead to you being in
danger of injury.
Bringing into use
Connecting the compressed air source
NOTE: Operate the product only with cleaned, con-
densate- and oil-free compressed air and never
exceed the maximum working air pressure at the
device of 8 bar.
NOTE: The compressed air source must be fitted
with a (filter) / pressure reducer so that the air pres-
sure can be regulated.
• Connect the product to a suitable compressed air
source by connecting the quick-release coupling
of the air supply hose with the plug-in nipple (4)
to the product. It locks itself in place automati-
cally.
Using the tyre inflator gauge (2)
1. Place the valve connector (5) on to the valve
2. Press the trigger (6) to start the delivery of air.
3. Release the trigger (6) to stop the delivery of air.
Read off the filling pressure on the gauge 1 .
4. If the object is overfilled with air (air pressure
too high): Press the deflator valve (3) to release
some air.
5. Press the lever of the valve connector (5) down-
wards and pull the valve connector (5) off the
valve.
6. After you finish work, disconnect the device from
the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the com-
pressed air supply hose from the device. This
will ensure that the compressed air supply hose
does not wave around in an uncontrolled man-
ner.
Using accessories:
• Press the lever of the valve connector (5) and insert
the desired accessory (10) to (13) or the cap (9) into
the valve connector (5)
Using the blow gun (7)
1. Screw an extension nozzle (8) on to the blow gun
(7) .
2. Press the trigger (6) to start the delivery of air.
3. Release the trigger (6) to stop the delivery of air.
4. After you finish work, disconnect the device from
the compressor. NOTE: First disconnect the hose
from the compressor and only then disconnect the
compressed air supply hose from the device. This
will ensure that the compressed air supply hose
does not wave around in an uncontrolled manner.
8 І 36
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Maintenance and cleaning
• DANGER OF INJURY! Always disconnect the
device from the compressed air source before you
clean or maintain it.
The device requires no maintenance.
• Do not use sharp objects for cleaning the device.
Do not allow any liquids to enter the device.
Otherwise the device could be damaged.
• Clean the device frequently; for best results, do this
immediately after you have finished using it.
• Clean the housing with a dry cloth.
Disposal and recycling
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask your dealer or your local council.