Prepare Measurement - Beurer BM 58 Gebrauchsanweisung

• Free memory on the primary partition of at least:
– x86 – 600 MB
– x64 – 1.5 GB
• Graphic resolution from: 1024 x 768 pixels
• USB port 1.0 or later

4. Prepare measurement

Inserting battery
• Push the cuff holder
upwards at the rear of the
device until it locks into
place.
• Open the battery com-
partment lid.
• Insert four AA 1.5 V alka-
line batteries. making absolutely sure that you insert them
with the correct polarity as marked. Never use recharge-
able batteries.
• Replace the battery cover carefully.
If the battery change
measurement is no longer possible and you must replace all
the batteries. Once batteries have been removed from the
device, the time must be reset.
Used batteries do not belong in the household waste. You
are legally obliged to dispose of the batteries. Dispose of
is continuously illuminated,
them via your specialist electrical supplier or local collec ting
point for recyclable waste.
Note: Batteries containing pollutant substances
are marked as follows: Pb = Battery contains
lead, Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting date and time
You should set the date and time without fail. Otherwise,
you will not be able to save your measured values correctly
with a date and time and to access them again later.
Tip: If you press and hold the MEM button, you can set the
values more quickly.
To set the date and time, proceed as follows:
• Move the touch screen activation switch to the ON posi-
tion.
• Press the START/STOP and MEM buttons simultane-
ously, 24h begins to flash. Select 12h or 24h mode using
the MEM button. Press START/STOP to confirm your
selection. The year display will start to flash. Set the year
with the MEM button and confirm with START/STOP
• Then set the month, day, hour and minutes and confirm
each setting with START/STOP
• Pressing the START/STOP button
display off.
22
.
.
again will switch the