Safety Instructions; General Safety; Electrical Shock Hazard - Dometic MCS T6 Montageanleitung

MCS T6, MCS T12, MCS T16
I
NOTE
Supplementary information for operating the product.
2

Safety Instructions

The manufacturer accepts no liability for damage in the following cases:
• Faulty assembly or connection
• Damage to the product resulting from mechanical influences and excess
voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
2.1

General Safety

!
WARNING!
• Danger of electrocution!
The units are AC voltage components, running on 230 V~.

• Electrical shock hazard!

Disconnect voltage at main panel or power source before opening any
cover.
Failure to comply may result in injury or death.
• To minimize the hazard of electrical shock and personal injury, this compo-
nent must be effectively grounded.
• This system does not meet requirements for ignition protection. Do not install
in spaces containing gasoline engines, tanks, LPG/CPG cylinders, regula-
tors, valves or fuel line fittings.
Failure to comply may result in injury or death.
• Do not terminate condensate drain line
– within 1 m of any outlet of engine or generator exhaust systems,
– in a compartment housing of an engine or generator,
– in a bilge, unless the drain is connected properly to a sealed condensate
or shower sump pump.
Failure to comply may allow bilge or engine room vapors to mix with the air
conditioners return-air and contaminate living areas which may result in
injury or death.
• In order to prevent the ingress of carbon monoxide (CO) or other harmful
vapors, a trap should be installed in the condensate drain line(s).
• Installation and servicing of this system can be hazardous due to system pres-
sure and electrical components.
• Never install your air conditioner in the bilge or engine room areas.
• Place a fire extinguisher close to the work area.
EN
Safety Instructions
11