Operation; Connecting Machine Plug; Adjusting The Splash Shield; Turning Thrust Clip - Kärcher BRS 40/550 C CARPET Betriebsanleitung

Operating Instructions
Initial fitting
Fitting thrust clip
Position the lower half of the
pushing handle vertically
Adjust the upper half of the pushing
handle and fix it with the knurled
screw
Note:
Do not jam cable when fitting
Installing the rotary
brushes
! Carefully lay the cleaner down
! Always use two rotary brushes of
the same type
Place the rotary brush with gearing
onto the drive
! Press the rotary brush down and
place it into the thrust bearing
! Install the second rotary brush as
described
! Check that the rotary brushes are
in the correct position
! Position the cleaner vertically
BRS 40/550 C CARPET

Operation

Connecting machine plug

! Connect the plug to the power
cable
! Hang the power cable in the
strain-reliever
! Plug the cable into the power
socket

Adjusting the splash shield

! Undo the fastening screw
! Set splash protection according
to pile height
! Set depth of splash protection so
that the granules cannot squirt or
be pushed away sideways
! Tighten fastening screw
Note:
Adjust the splash guard parallel to
the floor
English

Turning thrust clip

! Press the pushing handle
downwards and turn to the LEFT
or RIGHT
! Release strain on the pushing
handle and turn, it locks in
several positions
13