Storch DriveFixx Bedienungsanleitung Seite 87

REMOVING BITS (Fig. 11)
Lock the trigger switch by placing the direction-of-rotation selector in the OFF (center) position.
Open the chuck jaws.
NOTE:
Rotate the chuck body in the direction of the arrow marked OPEN to open the chuck jaws. Do not use a key
to tighten or loosen the jaws.
Remove the drill bit.
WARNING:
Insert the drill bit into the chuck jaws so that
it is straight. Do not insert the drill bit into the
chuck jaws at an angle and then tighten it (see
Fig. 12). This can cause the bit to be ejected
from the drill, which can result in severe perso-
nal injury or damage to the chuck.
DRILLING (Fig. 13)
Check that the direction- of-rotation selector is
at the correct setting (forward or reverse).
Secure the material to be drilled in a vise or with clamps
to keep it from turning as the drill bit rotates.
Grasp the drill firmly and hold the bit at the position to be
drilled.
Depress the trigger switch to start the drill.
Move the drill bit into the workpiece, applying only
enough pressure to keep the bit cutting. Do not force the
drill or apply side pressure to elongate a hole.
When drilling hard, smooth surfaces, use a center punch
to mark the desired location of the hole. This will prevent
the drill bit from slipping off-center as the hole is started.
When drilling metals, use light oil on the drill bit to keep
it from overheating. The oil will prolong the life of the bit
and increase the drilling action.
If the bit jams in the workpiece or if the drill stalls, stop
the tool immediately. Remove the bit from the workpiece
and determine the reason for jamming.
WARNING:
This drill driver is equipped with an electric brake. When the brake is working properly sparks can be seen
through the vents in the housing. This is a normal occurrence and a consequence of the braking process.
INCORRECT
INCORRECT
87