Storch DriveFixx Bedienungsanleitung Seite 85

TWO-SPEED GEARBOX (Fig. 7)
The drill driver has a two-speed gearbox designed for dril-
ling or driving at LO or HI speeds. A slide switch is located
on the top of the tool to select either LO or HI speed.
When the drill driver is operated using the LO setting the
speed is reduced and the drill exhibits more force and a
higher torque. The HI setting increases the speed and pro-
vides the drill driver with a higher driving power. Use the
LO setting for power and torque-intensive applications,
and use the HI setting for rapid drilling and screwing pro-
cedures.
Use the LO setting for starting holes without a centre
punch, drilling metal or plastic, drilling ceramics, or in
applications requiring a higher torque (see below).
The HI setting is better suited for drilling into wood and
wood composites.
NOTE:
Do not operate the drill driver for prolonged periods while in the LO setting. Continuous use of the LO setting
can result in the drill driver overheating. If it does overheat, cool the drill driver by operating it freely in the
HI setting.
ATTENTION:
Never change the setting while the machine is running. Failure to comply with this could result in serious
damage to the drill driver.
ADJUSTABLE-TORQUE CLUTCH (Fig. 8)
The Torque clutch can be adjusted to 17 different settings.
The higher the torque setting, the more force the drill pro-
duces to turn an object in either LO or HI rotation speed.
When using the drill driver for different driving applica-
tions, increase or decrease the torque in order to help pre-
vent damaging screw heads, threads, workpieces, etc.
Adjust the torque by rotating the torque-adjustment ring.
The setting depends on the task at hand, the type of
application, the mounting device and the material. Gene-
rally speaking a higher torque should be used for larger
screws. If the torque is too high, it can result in screws
being damaged or broken.
For delicate operations, such as removing a partially strip-
ped screw, use a low torque setting. For operations such
as drilling into hardwood, use a higher torque setting.
NOTE:
When adjusting the torque setting make sure that the switch is either completely in the LO or HI position.
ATTENTION:
Do not adjust the torque while the machine is running.
Two-speed switch
To reduce the torque
Torque adjust-
ment ring
85
To increase the torque