Storch DriveFixx Bedienungsanleitung Seite 82

HOW TO CHARGE THE BATTERY PACK
NOTE:
This lithium-ion battery pack is delivered partially char-
ged. Charge the battery pack fully prior to first use. A fully
discharged battery pack can be fully charged at an ambi-
ent temperature between 0°C and 40°C in approximately
30 minutes.
Charge the lithium-ion battery pack using the supplied
charger.
Connect the charger to a power supply.
Insert the battery pack into the charger (Fig. 2).
The green light will flash while the battery pack is char-
ging. After charging is complete, the green LED on the
charger will be on. The flickering red light indicates a
defective battery or a bad connection between the battery
and the charger.
The battery pack will fully charge if left on the charger,
but it will not overcharge.
NOTE:
The charger can be operated with the majority of genera-
tors and converters with a rated power of 300 watts or
above.
LED FUNCTIONS OF CHARGER (Fig. 3)
LED indicates HIGH / DEVICE TEM-
PERATURE
Battery pack Hot cold battery
Red LED On
Green LED Off
Action Charging starts when
the battery temperature
returns to between 0°C
and 40°C
CHARGING A HOT BATTERY PACK
If the temperature of the battery pack exceeds the normal temperature range, the red LED light will illuminate and the
green LED light will go out. When the battery pack cools down to approximately 40°C the charger will automatically
start the charging process.
CHARGING A COLD BATTERY PACK
If the temperature of the battery pack falls below the normal temperature range, the red LED light will illuminate and
the green LED light will go out. When the battery pack heats up to approximately 0°C the charger will automatically
start the charging process.
DEFECT
Defective
Flashes
Off
Barmy pack or charger
is defective
82
BATTERY CHARGING BATTERY FULL
Charging Fully charged
Off Off
Flashes On
Charges in 30 minutes Charging is com-
plete
Maintenance char-
gings