Battery Charging - Storch DriveFixx Bedienungsanleitung

DEFECTIVE BATTERY
If the charger detects a problem, the red LED will begin flashing and the green LED will be off.
If the battery pack is identified as defective, remove it and re-insert it into the charger. If the status of the LED lights
indicate a "defective" battery pack for a second time, charge another battery pack.
If the other battery pack is charged without any problems, dispose of the defective battery pack properly (see the sec-
tion entitled "Maintenance").
If the other battery pack is also identified as "defective", it is possible the charger is damaged.

BATTERY CHARGING

When the battery pack is charged at a normal ambient temperature (0°C to 40°C), the green LED light will flash and
the red LED light will remain off. The battery pack is fully charged in approximately 30 minutes.
BATTERY FULL
If the battery pack is within normal temperature range, the green LED will illuminate and the red LED will be off. The
battery pack is fully charged and ready to use. The battery pack will fully charge if left on the charger, but it will not
overcharge.
NOTE:
The charger can heat up in the event of multiple charging cycles. This is part of the normal charging process. Always
charge in well ventilated areas.
CONNECTING THE BATTERY PACK (Fig.4)
Make sure that the drill driver is set to "OFF".
Align the raised ribs on the battery pack with the grooves
in the drill and insert the battery pack into the drill.
NOTE:
Before using the tool make sure that the lock on the bat-
tery pack is engaged and that the battery pack is secured
to the tool.
REMOVING THE BATTERY PACK (Fig. 4)
Lock the trigger switch on the drill driver by actuating the direction switch (forward / reverse / switch lock) to the centre
position.
Depress the battery release buttons located on the both sides of the battery pack to release it.
Pull the battery pack out and remove it from the tool.
ATTENTION:
When installing the battery pack in the tool make sure that the raised rib on the battery pack is aligned with
the groove inside the drill driver and that the lock is engaged properly. Incorrect installation of the battery
pack can damage internal components.
WARNING:
Battery powered tools are always in an operational state. The direction of rotation switch should therefore
always be locked when the tool is not in use.
83