Operation Of Flow Through-Chamber; Flow-Through Mode; Circulation Mode; Analytical Mill Attachment Ax 60 - CAT UNIDRIVE X1000 Bedienungsanleitung

6 Operation of Flow Through-Chamber

6.1

Flow-Through Mode

Connect the vessel containing the media to the inlet by a tube (inner Diameter = 20 mm).
Connect another tube (inner Diameter = 20 mm) to the outlet and lead it to a collecting basin.
Note: Secure all tube connections with suitable tube clips.
6.2

Circulation Mode

Connect in and outlet tube as described in 6.1 and lead the outlet tube back into the original
vessel. This way the medium might flow several times through the in-line unit.
Note: The flow-through-chamber is not self-priming. Inlet tube and flow through chamber have
always to be filled with a medium. We therefore recommend to set up the vessel
containing the sample at the same height as the flow through chamber and to additionally
fit a blockage (for example a ball valve) to the connecting tube.

7 Analytical Mill Attachment AX 60

7.1

Description of the Analytical Mill Attachment AX 60

For analysis, material testing and quality control of organic and inorganic substances of various
hardness. The grinding chamber consists of two stainless steel beakers, both with separate cooling
facilities. The total capacity of the grinding chamber is 180 cm³. The two grinding chambers are –
when closed – sealed with an o-ring to prevent from dust and losses. This analytical mill is
especially developed to also enable the use of coolants such as N2 or to crush and analyse
material that is best crushed when super cooled. The complete grinding chamber is connected by
a mechanical clutch to the drive unit UNIDRIVE X1000 or UNIDRIVE X1000D. The speed control of
these motors allow for a smooth start of the grinding mill at low speed. Extremely rapid
disintegration of the material is possible due to the very high maximum speed of these motors.
The grinding cutter knife (19) declutches when the grinding chamber is opened. The design
prevents from unintended run of the cutter when the chamber is not closed.
Upper vessel of
grinding chamber (14)
Instruction Manual UNIDRIVE X1000/X1000D 2011/08 V3.00
Upper grinding
chamber (13)
Lower vessel of grinding
chamber (15)
Lower grinding
chamber (16)
Page/Seite 17 von/of 47