Inserting The Homogenizing Tool - CAT UNIDRIVE X1000 Bedienungsanleitung

4.4.1 Inserting the Homogenizing Tool

The Generators have sharp edges. Handle with care. Risk of injuries!
The homogenizing tool comes always assembled. The connecting adapter (drive pin (11)) is located
on the top of the Shaft and is used to attach the Shaft to the drive motor. When inserting the
homogenising tool, make sure that the coupling fits well. This can be easily detected by the "click"
that is heard when the coupling Shaft has reached the end of the coupling slot of the motor.
Securely fasten the holding screw (6).
Never run homogenising tools dry as the bearings and gaskets will be damaged if
the Generator is not cooled by the medium. The distance between the homogenising
tool and the vessel bottom should not be less than 10mm. The filling of the medium
may not be less than about 55 mm. To avoid a vortex it is necessary to insert the
dispersing Shaft out of the centre of the vessel. If these conditions are met the unit is
ready for operation.
Instruction Manual UNIDRIVE X1000/X1000D 2011/08 V3.00
holding screw (6)
drive pin (11)
Page/Seite 12 von/of 47