Maintenance Homogenizing Tools; Dismantling, Transport And Storage; Dismantling; Transport And Storage - CAT UNIDRIVE X1000 Bedienungsanleitung

9.7

Maintenance homogenizing tools

The Generators have sharp edges. Handle with care. Risk of injuries!
The gaskets in the homogenizing tools must be constantly monitored. In the event of leakage the
suction effect of the rotating Shaft can cause the medium to penetrate as far as the drive unit. If
liquid emerges from the side hole at the top of the Shaft tube stop work immediately and check
the gaskets. The function of the Generators depends on the condition of the sharp edges on the
rotor and stator. These edges may be blunted very quickly in abrasive media, reducing the
effectiveness of homogenizing.

10 Dismantling, Transport and Storage

10.1 Dismantling

1. Switch the unit off.
2. Disconnect it form the mains supply.
3. Remove any glass beakers and any other equipment around the drive unit.
4. Remove the homogenizing tool by loosening the holding screw (6).
5. Loosen the special clamp and remove the clamp from the support rod.
6. Unscrew the support rod.
7. Now you may remove the instrument from the working area.

10.2 Transport and Storage

Prior to transport:
Switch the instrument off and proceed with dismantling as described under "Dismantling".
Place the instrument and its parts in its original packaging or another suitable container to protect
it during transport. Close the packaging with adhesive tape.
Store the instrument in a dry environment. Please observe the specified conditions of the ambient
(temperature and humidity).
Do not subject the instrument to mechanical shocks or vibration during transporting it.
In case you do not use the original packaging please mark the box with the following notes:
 Glass symbol (handle with care, fragile)
 Umbrella (keep dry)
 Content (list of content)
 Storage ambient:
Max. ambient temperature : RT to +40°C
Max. humidity:
Instruction Manual UNIDRIVE X1000/X1000D 2011/08 V3.00
80%
Page/Seite 21 von/of 47