Attaching The Drive Unit To A Stand; Description Of A Homogenising Tool - CAT UNIDRIVE X1000 Bedienungsanleitung

4.3.2 Attaching the Drive Unit to a Stand

To ensure safe operation mount the drive unit to a stand using a cross over clamp (9).
Vibrations may loosen the clamp screws (10). Please check periodically whether all
holding screws are securely tight.
Cross over clamp (9)
 Attach cross over clamp (9) to a stand rod.
 Now attach the drive unit to the stand by inserting
the support rod (8) into the free opening of the cross over clamp (9).
 Tighten screws (10) of the cross over clamp (9).
4.4

Description of a Homogenising Tool

Generator (12)
consisting of
rotor and stator
Instruction Manual UNIDRIVE X1000/X1000D 2011/08 V3.00
clamp screws (10)
drive pin (11)
Page/Seite 11 von/of 47