Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before starting the unit make sure that
the speed is set to the lowest speed
the Generator (12) of the homogenising tool is inserted in the fluid. To avoid a
vortex it is necessary to insert the dispersing Shaft out of the centre of the vessel.
the vessel is protected against rotating, shaking or moving
make sure that the air ventilation slots (4) are always open, as this is necessary for
cooling purposes
Start the unit always at the lowest speed and then gradually increase the speed to the desired
level.
4.5.2 Description of the Speed Scale X1000 and X1000D:
1
2
3
4
5
6
The set speed of UNIDRIVE X1000D is shown the speed display (5).
4.6
Exchanging the Homogenizing Shafts
Prior to exchange the homogenizing shaft disconnect the unit from the mains supply by
unplugging the unit.
Loosen the holding screw (6) and firmly pull out the Shaft by hand. It will disconnect easily.
When inserting another Shaft, make sure that the coupling fits well. This can be easily
detected by the "click" that is heard when the coupling Shaft has reached the end of the
coupling slot of the motor.
Securely fasten the holding screw (6).
4.6.1 Exchanging the Generator:
The Generators have sharp edges. Handle with care. Risk of injuries!
To exchange the Generator (rotor and stator), always take the Shaft out of the motor drive unit as
described under 4.6.
For undoing the rotor, use the two special keys (to be ordered separately). The socket wrench is
used to counter-hold the Shaft, and the rotor wrench to undo the rotor.
To exchange the stator, remember that the fastening thread is counter-clockwise.
You will find further detailed descriptions in the instruction manual which comes with each
homogenising tool.
Important Note
Always unscrew the rotor first before unscrewing the stator.
Instruction Manual UNIDRIVE X1000/X1000D 2011/08 V3.00
=
4000 rpm
=
8500 rpm
=
15000 rpm
=
20000 rpm
=
25000 rpm
=
33000 rpm
Page/Seite 14 von/of 47
Werbung
Inhaltsverzeichnis
